Intel 6000 ユーザーズマニュアル
Quick Start
Set up the switch
For complete installation requirements,
see the User Guide.
see the User Guide.
1 Remove the switch and parts from the
box.
2 If you plan to install the switch in a 19-
inch rack, remove the four front panel
screws on each side of the unit, then use
the screws included in the accessory kit
to fasten the rack-mount brackets.
screws on each side of the unit, then use
the screws included in the accessory kit
to fasten the rack-mount brackets.
3 Install the switch in a rack or on a shelf.
Install the carrier
tray module
tray module
1 Slide the carrier tray module into Slot 5
(the bottom slot) until it meets the con-
nector inside the chassis, and the capture
panel screws engage the chassis.
nector inside the chassis, and the capture
panel screws engage the chassis.
2 Tighten both capture panel screws
simultaneously.
Install the Control
Processor module
Processor module
1 Slide the Control Processor (CP) mod-
ule into the left side of the carrier tray.
2 Push the module back until it meets the
connector inside the chassis, and the
capture panel screws engage the carrier
tray.
capture panel screws engage the carrier
tray.
3 Tighten both capture panel screws
simultaneously.
4 If you ordered a second module, remove
the face plate on the right side of the
bottom slot and follow the instructions
above to install the module.
bottom slot and follow the instructions
above to install the module.
1
Front Panel Screws
2
Carrier Tray
Gender
Adapter Bar
Adapter Bar
Slot 5
3
Primary CP
Slot 5