Intel 6000 ユーザーズマニュアル

2

If you purchased an additional power sup-
ply, place it in one of the empty power 
supply bays at the top of the chassis.

1 Loosen and remove the capture panel 

screws on the face plate of the power 
supply bay.

2 Push the power supply into the power 

supply bay until the capture panel 
screws engage the chassis.

3 Tighten the capture panel screws.

You can install network modules, such as 
the 1000Base-SX, 1000BaseLX /
1000BaseSX and 10/100Base-TX, in any 
available slot on the chassis 

1 Remove the filler panels from any slots 

(1-4) that will hold network modules.

2 Push the module back until it connects 

with the backplane connector, and the 
capture panel screws engage the chassis.

3 Tighten both capture panel screws 

simultaneously.

4 Leave the filler panels in any unused 

slots. Doing so keeps dust out of the 
switch and helps maintain proper air-
flow.

Capture Panel
Screws

Gigabit
Ethernet
Module