Sony SRX-R105 ユーザーズマニュアル

GB 

24

Projecting the Picture 

  

Ch
apt

er 3  Proj

ec
tin
g

When you select the input from the connectors on the 
LKRI-001 input board, select the appropriate input 
signal from “Mode” of “Input Source” in the 
PICTURE CONTROL window. Improper setting may 
cause deterioration of the picture.

When you select “dual-screen mode” or 
“quad-screen mode” in step 5
Select the input source for each screen from the 
corresponding drop-down list box.

When projecting moving pictures in multiple screens, 
all the input signals should be genlocked to 
synchronize with each other. A picture on the left 
screen for dual-screen mode or that on the upper left 
screen for quad-screen mode is regarded as a reference 
picture. The projected moving picture not 
synchronized with the reference picture appears 
incompatible with the moving pictures projected on 
other screens. If you project still pictures and moving 
pictures together, select the left screen for the moving 
picture in dual-screen mode or the upper left screen in 
quad-screen mode. If you project still pictures only, 
you may project them on any screen.

Click the “INSTALLATION” button to open the 
INSTALLATION window.

Adjust the focus with the Focus +/– buttons.

During adjustment, “FOCUS” appears on the screen.

Adjust the picture size with the Zoom +/– buttons.

During adjustment, “ZOOM” appears on the screen.

Adjust the focus again with the Focus +/– buttons.

Adjust the vertical position of the picture with the Shift 
+/– buttons.

During adjustment, “SHIFT” appears on the screen.

The FOCUS, ZOOM and SHIFT indications do not appear 
when you select “OSD OFF” in the SCREEN CONTROL 
window.

Click “ON” of the CUT OFF buttons.
When you select the dual-screen mode or quad-screen 
mode, you can cut off the picture of each screen 

independently. Click “ON” of the CUT OFF buttons of 
each screen.
To restore the picture, click “OFF” of the CUT OFF 
buttons.

Click the MUTING ON button. The whole screen appears 
in black. To restore the picture, click the MUTING OFF 
button. 

Click the POWER STANDBY 

1 button, then the OK 

button in the displayed confirmation dialog.

The POWER and STATUS LAMP indicators flash 
green and the fan continues to run for 10 minutes to 
reduce the internal heat. When the fan stops running, 
the POWER and STATUS LAMP indicators light red.

Set the main power switch to the lower position.

Do not switch the main power switch to the lower (off) 
position while the fan is running. Doing so stops the 
fan before the inside of the projector has been cooled 
down sufficiently and may damage the unit.