Viewsonic PJ1172 ユーザーズマニュアル

With the AUTO menu, the items shown in the table below can be 

performed. Perform each operation in accordance with the 

instructions in the table below.

(This table is continued to the following page.)

Item

Description

ADJUST

Pressing the X (or the ENTER) button performs the automatic 

adjustment.

At a RGB signal
The vertical position (V POSITION), the horizontal position (H 
POSITION), the clock phase (H PHASE) and the horizontal size (H 
SIZE) will be automatically adjusted.

Make sure that the application window is set to its maximum size 

prior to attempting to use this feature. Dark pictures may still be 

incorrectly adjusted. Use a bright screen when adjusting.

At a video signal
The signal type mode best suited for the respective input signal will 
be selected automatically.

This function is available only when AUTO is selected to the item 

“VIDEO” of the INPUT menu. For a component video signal, the signal 

type is identified automatically independently of this function.

This operation requires approximately 10 seconds, and the 

message “AUTO IN PROGRESS” is displayed during the operation.

This operation may not work well at some signals. If the picture 

becomes unstable (ex. a irregular picture, a color lack), please select 

the suitable mode to the item “VIDEO” of the INPUT menu.

POWER OFF

Set the time using the S/T buttons.: 

    Long (max. 99 minutes)  Short (min. 0 minute = DISABLE)

                          ex.  

When the time is set to 1 to 99, the projector lamp will go off and the 

STANDBY/ON indicator begins blinking when the passed time with a 

proper signal (without no-signal and an unsuitable signal) reaches at 

the set time. Please refer to the section “Turning Off The Power”.

POWER ON

Select TURN ON or TURN OFF using the S/T buttons.:

    TURN ON  TURN OFF
When TURN ON is selected, you can turn the projector on without 

pressing the STANDBY/ON button. Please refer to the section 

“Turning Off The Power”.