Zebra Technologies UMAN-QLP-001 ユーザーズマニュアル
52
QL Plus Series User Guide
General Cleaning Instructions
Caution • Avoid possible personal injury or damage to the printer: never
insert any pointed or sharp objects into the printer.
Always turn the printer off before performing any cleaning
procedures.
Use care when working near the tear bar. The edges are very sharp.
Caution • The printhead can be very hot after prolonged printing.
Allow it to cool off before attempting any cleaning procedures.
Only use the cleaning pen supplied with the printer or a cotton swab
saturated with alcohol for cleaning the printhead.
Caution • Use only cleaning agents specified in the following tables.
Zebra Technologies Corporation will not be responsible for damage
caused by any other cleaning materials used on this printer.
QL 220 Plus Cleaning
Area
Method
Interval
Printhead (Figure 22)
Use the supplied cleaning pen or
70% isopropyl alcohol on a cotton
swab to clean the print elements
from end to end (the print elements
are located in the thin gray line on
the printhead).
70% isopropyl alcohol on a cotton
swab to clean the print elements
from end to end (the print elements
are located in the thin gray line on
the printhead).
After every five rolls of
media (or more often, if
needed),
Linerless media requires
more frequent cleaning
media (or more often, if
needed),
Linerless media requires
more frequent cleaning
Platen Roller (Figure 22)
Rotate the platen roller and clean it
thoroughly with the cleaning pen or
70% isopropyl alcohol and a cotton
swab.
thoroughly with the cleaning pen or
70% isopropyl alcohol and a cotton
swab.
Platen Roller
(Figure 22a)
(Figure 22a)
Units with linerless platens: Rotate
platen & clean bearing points only.
Avoid use of alcohol on the surface
of linerless platens
platen & clean bearing points only.
Avoid use of alcohol on the surface
of linerless platens
Peel bar (Figure 22)
Clean thoroughly with the cleaning
pen or 70% isopropyl alcohol and a
cotton swab.
pen or 70% isopropyl alcohol and a
cotton swab.
As needed
Scraper, Linerless units
only (Figure 22))
only (Figure 22))
After every five rolls of
media (or more often, if
needed)
media (or more often, if
needed)
Tear bar (Figure 22)
As needed
Exterior
Water-dampened cloth
Interior (Figure 22)
Brush/air blow. Ensure the Bar
Sensor, Gap Sensor and Label
Present Sensor windows are free
of dust.
Sensor, Gap Sensor and Label
Present Sensor windows are free
of dust.
Units with linerless platens: Clean
inside surfaces of edge guides &
media rollers with the supplied
cleaning pen or 70% isopropyl
alcohol on a cotton swab.
inside surfaces of edge guides &
media rollers with the supplied
cleaning pen or 70% isopropyl
alcohol on a cotton swab.
After every five rolls of
media (or more often, if
needed)
media (or more often, if
needed)
Interior (Figure 22a)