Zebra Technologies RW 420 ユーザーズマニュアル
17
RW Series User Guide
Fault
Fast Ch
arge
Fault
Fast Ch
arge
Fault
Fast Ch
arge
Ready
Power
Full Ch
arge
Ready
Full Ch
arge
Ready
Full Ch
arge
Full Ch
arge
Fault
Fast Ch
arge
Ready
Figure 6: UCLI72-4 Quad Charger
Model UCLI72-4 Quad Charger
The UCLI72-4 Quad Charger is designed to charge up to four
RW Series battery packs simultaneously. Batteries must be
removed from the printer to be charged in the Quad Charger.
removed from the printer to be charged in the Quad Charger.
1. Ensure that the charger has been installed properly per
the Quad Charger instruction manual. Ensure that the
power indicator on the front panel is on.
power indicator on the front panel is on.
2. Remove any protective shrink-wrap and labels from all
battery packs prior to use. Plug a battery pack into any
one of the four charging bays as shown in Figure 6, not-
ing the orientation of the battery pack. Slide the battery
pack into the charging bay until it stops. Then rock the
battery pack back until it snaps into place. The amber in-
dicator directly under the battery being charged will turn
on if the battery is properly inserted.
one of the four charging bays as shown in Figure 6, not-
ing the orientation of the battery pack. Slide the battery
pack into the charging bay until it stops. Then rock the
battery pack back until it snaps into place. The amber in-
dicator directly under the battery being charged will turn
on if the battery is properly inserted.
The indicators under the battery will allow you to monitor
Amber
LED
LED
Green
LED
LED
2. Rock Battery Pack into
place
1. Slide Battery Pack into Charger
Bay
Power Indicator
Power Supply
Charger Bay