DELL 8132 ユーザーズマニュアル

ページ / 1818
1112
IPv6 Routing Commands
ping ipv6 interface
Use ping ipv6 interface command in the Privileged EXEC mode to 
determine whether another computer is on the network. To use the 
command, configure the switch for network (in-band) connection. The 
source and target devices must have the ping utility enabled and running on 
top of TCP/IP. The switch can be pinged from any IP workstation with which 
the switch is connected through the default VLAN (VLAN 1), as long as there 
is a physical path between the switch and the workstation. The terminal 
interface sends three pings to the target station. Use the interface keyword to 
ping an interface by using the link-local address or the global IPv6 address of 
the interface. The source can be a loopback, tunnel, or logical interface. 
Syntax
ping ipv6 interface
 {vlan vlan-id | tunnel tunnel-id} | loopback loopback-
id} link-local-address [size datagram-size] 
vlan-id — Valid VLAN ID. 
tunnel-id — Tunnel identifier. (Range: 0-7)
loopback-id — Loopback identifier. (Range: 0-7)
link-local-address — IPv6 address to ping.
datagram-size — Size of the datagram. (Range: 48-2048 bytes)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example determines whether another computer is on the 
network at the IPv6 address specified.
2CSPC4.X8100-SWUM102.book  Page 1112  Friday, March 15, 2013  8:56 AM