DELL 8132 ユーザーズマニュアル

IPv6 Routing Commands

The long form of the command includes the same annotations and shows 

whether address autoconfiguration or DHCP client are enabled on the 

interface. When the interface acts as a host interface, the output also shows 

the default gateway on the interface, if one exists.

The following example shows the method of assignment for each IPv6 address 

that is either autoconfigured or leased from a DHCP server.

console#show ipv6 interface 

           Oper.

Interface  Mode     IPv6 Address/Length

---------- -------- ---------------------------------

Vl3        Enabled  FE80::211:88FF:FE2A:3E3C/128

                    2033::211:88FF:FE2A:3E3C/64

Vl5        Enabled  FE80::211:88FF:FE2A:3E3C/128

                    2017::A42A:26DB:1049:43DD/128 [DHCP]

Vl7        Enabled  FE80::211:88FF:FE2A:3E3C/128

                    2001::211:88FF:FE2A:3E3C/64 [AUTO]

Vl9        Disabled FE80::211:88FF:FE2A:3E3C/128 [TENT]

The Method column shows one of the following values:

• Auto – The IPv6 address was automatically generated using IPv6 auto 

address configuration (RFC 2462)

• Config – The IPv6 address was manually configured.
• DHCP – The IPv6 address was leased from a DHCP server.
• TENT – Tentative address.

The following example displays the long form of the command, and indicates 

whether address autoconfiguration or DHCP client are enabled on the 

interface. When the interface acts as a host interface, the output also shows 

the default gateway on the interface, if one exists.

TENT

Tentative address.

2CSPC4.X8100-SWUM102.book  Page 1115  Friday, March 15, 2013  8:56 AM