DELL 8132 ユーザーズマニュアル
1608
Sflow Commands
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
The default poll interval is 0.
Command Mode
Global Configuration mode.
User Guidelines
The sflow instance must be configured using the sflow destination owner
command before this command can successfully execute.
Example
console(config)#sflow 1 polling gigabitethernet 1/0/1-10 200
sflow polling (Interface Mode)
Use the sflow polling command in Interface Mode to enable a new sflow
poller instance for this interface if rcvr_idx is valid. An sflow poller sends
counter samples to the receiver. Use the "no" form of this command to reset
poller parameters to the defaults.
Syntax
sflow
rcvr-index polling poll-interval
no sflow
rcvr-index polling
•
rcvr-index — The sFlow Receiver associated with the poller (Range: 1 - 8).
•
poll-interval — The sFlow instance polling interval. A poll interval of 0
disables counter sampling. A value of n means once in n seconds a counter
sample is generated. (Range: 0 - 86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
The default poll interval is 0.
2CSPC4.X8100-SWUM102.book Page 1608 Friday, March 15, 2013 8:56 AM