DELL 8132 ユーザーズマニュアル

System Management Commands

! Prefer the RJ45 port and leave the SFP port powered 

on

console(config-if-Te1/0/24)#media-type auto-select 

rj45

Use the member command in Stack Global Configuration mode to pre-

configure a switch stack member. Execute this command on the Management 

Switch. To remove a stack-member configuration from the stack, use the no 

form of the command.

  The no form of the command may not be used if the member is present in the stack.

unit switchindex

•

unit — The switch identifier of the switch to be added or removed from 

the stack. (Range: 1–12)

•

switchindex — The index into the database of the supported switch types, 

indicating the type of the switch being preconfigured. The switch index is 

a 32-bit integer obtained from the 

 command.

This command has no defaults.

Stack Global Configuration

The switch index (SID) can be obtained by executing the 

 command in User Exec mode. When removing a unit from a 

stack, use the no member command to remove the stack member 

configuration after physically removing the unit.

2CSPC4.X8100-SWUM102.book  Page 1696  Friday, March 15, 2013  8:56 AM