DELL 8132 ユーザーズマニュアル

Address Table Commands

port security [discard] 
no port security

• discard — Discards frames with unlearned source addresses. This is the 

default if no option is indicated.

Disabled

—

No port security

Interface Configuration (gigabitethernet, port-channel, tengigabitethernet, 

fortygigabitethernet) mode

When port security is enabled on an interface, all dynamic entries learned up 

to that point are flushed, and new entries can be learned only to the limit set 

by the port security max command. The default limit is 100 dynamic MAC 

addresses.

In this example, frame forwarding is enabled without learning, and with traps 

sent every 100 seconds on port gi1/0/1.

console(config)#interface gigabitethernet te1/0/1

console(config-if-Te1/0/1)#port security trap 100

Use the port security max command in Interface Configuration mode to 

configure the maximum addresses that can be learned on the port while the 

port is in port security mode. To return to the system default, use the no form 

of this command.

port security max 

max-addr

2CSPC4.X8100-SWUM102.book  Page 305  Friday, March 15, 2013  8:56 AM