DELL 8132 ユーザーズマニュアル

Ethernet Configuration Commands

support all speeds, even if they are available in the command. Entering an 

unsupported speed will produce the following error message An invalid 
interface has been used for this function. 

Fiber ports do 

not support auto-negotiation. Both ends of fiber connections must be set to 

full-duplex and the same speed.

The following example configures the speed operation of Ethernet port 1/0/5 

to advertise 100-Mbps operation only.

console(config)#interface gigabitethernet 1/0/5

console(config-if)#speed 100

Use the storm-control broadcast command in Interface Configuration mode 

to enable broadcast storm recovery mode for a specific interface. If the mode 

is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast 

traffic ingressing on an interface increases beyond the configured threshold, 

the traffic will be dropped. Therefore, the rate of broadcast traffic will be 

limited to the configured threshold. 

storm-control broadcast [level | 

rate]

• level— The configured rate as a percentage of link-speed.
•

rate — The configured rate in kilobits per second (kbps). (Range: 0-100)

The default value is 5.

Interface Configuration (Ethernet) mode

This command has no user guidelines.

2CSPC4.X8100-SWUM102.book  Page 431  Friday, March 15, 2013  8:56 AM