DELL 8132 ユーザーズマニュアル

ページ / 1818
502
IP Addressing Commands
User Guidelines
When DHCPv6 is enabled on the Out-of-Band interface, the system 
automatically deletes all manually configured IPv6 addresses on the interface.
DHCPv6 can be enabled on the Out-of-Band interface only when IPv6 auto 
configuration or DHCPv6 is not enabled on any of the in-band management 
interfaces.
IPv6 auto configuration mode can be enabled in the Out-of-Band interface 
only when IPv6 auto configuration or DHCPv6 is not enabled on any of the 
in-band management interfaces.
ipv6 address dhcp
Use the ipv6 address dhcp command in Interface (VLAN) Configuration 
mode to enable the DHCPv6 client on an IPv6 interface. 
Syntax
ipv6 address dhcp
no ipv6 address dhcp
Parameter Description
This command does not require a parameter description.
Default Configuration
DHCPv6 is disabled by default on routing interfaces.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only applies to VLAN routing interfaces. When DHCPv6 is 
enabled on a VLAN routing interface, the system automatically deletes all 
manually configured IPv6 addresses on the interface.
Use the no ipv6 address dhcp command to release a leased address and to 
disable DHCPv6 on an interface. The command no ipv6 address does not 
disable the DHCPv6 client on the interface.
2CSPC4.X8100-SWUM102.book  Page 502  Friday, March 15, 2013  8:56 AM