DELL 8132 ユーザーズマニュアル

IP Addressing Commands

This command will fail if DHCPv6 server has been configured on the 

interface.

In the following example, DHCPv6 is enabled on interface vlan2.

console#config

console(config)#interface vlan2

console(config-if-vlan2)#ipv6 address dhcp

Use the ipv6 enable command in Interface Config mode to enable IPv6 on a 

routing interface. Use the no form of this command to reset the IPv6 

configuration to the defaults.

IPv6 is not enabled by default.

Interface Configuration mode (VLAN, loopback)

There are no user guidelines for this command.

console(config)#no ipv6 enable

2CSPC4.X8100-SWUM102.book  Page 503  Friday, March 15, 2013  8:56 AM