HP (Hewlett-Packard) D3J88UT#ABA ユーザーズマニュアル
RAID 1 configuration
Follow these steps to configure an Integrated Mirroring (IM) volume with the BIOS-based configuration
utility. The procedure assumes that the system has the required drives and drive controllers.
1.
During BIOS startup, press
Ctrl-C
when prompted to start the LSI Logic Configuration Utility.
2.
Using the arrow keys, navigate to:
a. An appropriate adapter, then press
Enter.
b. RAID Properties, then press
Enter.
c.
Create IM Volume, then press
Enter.
3.
To configure a two-disk mirrored volume with an optional hot spare disk:
a. In the Create New Array screen, select the primary disk for the IM volume (the disk with
the data you want to mirror.)
b. Navigate to the RAID Disk column for this disk, then use the
Space
bar and
+
or
–
arrows
to select Yes. The value in the Array Disk column changes to Primary.
NOTE:
If partitions are defined on the selected disk, a message warns you that data on the
disk will be lost when the mirrored volume is created.
c.
Navigate to the secondary (mirrored) disk for the IM volume and set the Array Disk column
value to Yes.
NOTE:
If partitions are defined on the selected disk, a message warns you that data on the
disk will be lost when the mirrored volume is created.
d. Press
Delete
to confirm that the data on the disk can be erased, or press any other key to
deselect the disk.
4.
When all drives are selected, press
C
to create the array. Navigate to Save changes then
exit this menu and press
Enter.
5.
When the new array is created, the Adapter Properties screen appears. Press
Esc
twice, then
select Exit.
172
Appendix B Configuring RAID devices