HP (Hewlett-Packard) H2D81US ユーザーズマニュアル
System board
NOTE:
Read
before servicing this component.
This section describes replacing the system board.
Removing the system board
To remove the system board:
1.
2.
Remove the side access panel (see
3.
and then remove the CPU heatsink (see
TIP:
Make a note of the cable connections before disconnecting them from the system board.
For more information, refer to
.
4.
Disconnect all cabling from the system board.
5.
Gently squeeze the release mechanism as shown in the following figure.
Figure 5-34
Removing the system board
6.
Lift the system board slightly to clear the release mechanism and then pull the board away from
the rear of the chassis and then lift the system board upward
the rear of the chassis and then lift the system board upward
2
out of the chassis.
Installing the system board
To install the system board:
1.
Insert the system board with the rear chassis side of the board tilted slightly downward.
2.
Push back on the board while maintaining downward pressure on the board to clear the release
mechanism. The latch should click into place.
mechanism. The latch should click into place.
3.
to identify
power cables.)
106 Chapter 5 Replacing components
ENWW