HP (Hewlett-Packard) H2D81US ユーザーズマニュアル

Read 

 before servicing this component.

Before accessing the internal components of the workstation, you must remove the side access panel.

This section describes how to remove and install the side access panel.

To remove the side access panel:

Before removing the workstation side access panel, be sure that the workstation is

powered off and that the power cord is disconnected from the electrical outlet.

Disconnect power from the workstation (see 

Remove locks that are present such as a cable lock.

Pull up on the handle  , slide the cover 1/2-inch towards the rear of the system 

2

, then rotate the

cover off the chassis   as shown in the following figure.

  Removing the side access panel

To install the side access panel:

Align the bottom groove of the side panel with the bottom edge of the chassis.

Rotate the side panel toward the chassis, slide the panel forward to engage the fingers on the top
cover as well as the latch, then press firmly until the latch engages.

ENWW

Removing and installing components

69