Emerson ATCA-S201 ユーザーズマニュアル
RTM-ATCA-SXXX Overview
6806800H62B
ATCA‐S201 Installation and Use Guide
42
CLI command syntax
Table 19 CLI command syntax, set network property: assign NTP server
Convention:
atca_blade set_network Y 10+ <server1> … [server5]+
<server1>
… <server5>
Enter one to five NTP servers, specified as Dotted decimal or domain addresses
(time.nist.gov)
(time.nist.gov)
4.6.8 Network time protocol - NTP (On/Off)
<Read/Write> Users may enable NTP protocol service to synchronize the ATCA-
S201’s clocks with a known good reference time source.
4.6.9 Ethernet network port identification
The ATCA-S201 provides multiple Ethernet interfaces that host blades may use to
access storage. Whether using the CLI or web based configuration tools, these
access storage. Whether using the CLI or web based configuration tools, these
ports are identified with the Linux resource labels shown in the table below
Table 20 Ethernet ports for chassis communications (base/fabric)
Linux interface identifier
Port Description
/dev/eth0
10/100/1000 — Base 0 (Zone -2)
/dev/eth1
10/100/1000 — Base 1 (Zone -2)
/dev/eth2
10/100/1000 — Management (RTM, Rear I/O management
port)
port)
/dev/eth3
10G — Fabric 0 (Zone-2 XAUI )
/dev/eth4
10G — Fabric 1 (Zone-2 XAUI )
The webtool provides a table for each Ethernet resource. Users may enter new settings for any field,
and click the submit button located at the top of the screen to apply the settings.
Management[eth#] Network configuration
IP Address
Network Mask
Broadcast
Gateway
MTU Size
MAC Address
Active Settings
192.168.200.32
255.255.255.0
192.168.200.255
192.168.200.1
1500
00:11:0D:xx:xx:xx
New Settings
DHCP
Enable
dhcp
1500
0.0.0.0
0.0.0.0
0.0.0.0