Cobalt Networks 8321(-C) ユーザーズマニュアル

ページ / 48
8310/8321 User Manual 
••••
 (V 1.0)
Page 27
1.
 
Open the CFM-8310 package and remove the components. Verify that all necessary
components are included.
 
Fan PCB 8310A-016
 
Fan Filter S985-006
 
8 nuts 650-007
 
8 washers 960-025
 
MFC-8310(-N) Frame Controller Card
2.
 
Turn frame power off.
3.
 
Open the frame door.
4.
 
Carefully remove the door from the frame by unscrewing the two screws that attach
the door to the extender arms.
5.
 
Place the frame door inside up on a clean antistatic workspace.
6.
 
Insert the Fan Filter with the panhandle over the smaller fan vents and the cut corner
adjacent to the LED pipes already on the door. Gently push the filter down so the
mounting bolts pass through cleanly.
7.
 
Place a washer on each of the 8 mounting bolts.
8.
 
Align the Fan PCB with the fans up so the LED pipes pass through their board holes.
9.
 
Ensure the Alarm Mute button clears its door hole and that the Fault and Fan Fail
LEDs clear their door holes while you slowly press the Fan PCB down onto the 8
mounting bolts. See Figure 11 for details on these item locations.
10.
 
On the frame door, check that the Alarm Mute button pushes in and out without
binding.
11.
 
Tighten the 8 nuts until they just make contact with the rubber grommets on the
8310A-016 Fan PCB. Do not over tighten.
12.
 
Reconnect the door to the frame extender arms with the two screws from step 4.
This completes the procedure to install the Fan Board component of the CFM-8310 module. Next you
will learn about the CFM-8310 functions and user controls.
Cooling Fan Functions and User Controls
The CFM-8310 provides LED and Alarm switching controls to the front edge of the 8310 frame door.
Refer to Table 4 for details on LED functions for the MFC-8310 controller card.
Figure 10.   Frame Door Features