DELL 9.8(0.0) ユーザーズマニュアル
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series.
Usage
Information
Information
With each flap, Dell Networking OS penalizes the interface by assigning a penalty
(1024) that decays exponentially depending on the configured half-life. After the
accumulated penalty exceeds the suppress threshold value, the interface moves to
the Error-Disabled state. This interface state is deemed as “down” by all static/
dynamic Layer 2 and Layer 3 protocols. The penalty is exponentially decayed based
on the half-life timer. After the penalty decays below the reuse threshold, the
interface enables. The configured parameters are as follows:
(1024) that decays exponentially depending on the configured half-life. After the
accumulated penalty exceeds the suppress threshold value, the interface moves to
the Error-Disabled state. This interface state is deemed as “down” by all static/
dynamic Layer 2 and Layer 3 protocols. The penalty is exponentially decayed based
on the half-life timer. After the penalty decays below the reuse threshold, the
interface enables. The configured parameters are as follows:
• suppress-threshold should be greater than reuse-threshold
• max-suppress-time should be at least 4 times half-life
• max-suppress-time should be at least 4 times half-life
NOTE: You cannot apply dampening on an interface that is monitoring traffic
for other interfaces.
for other interfaces.
Example
Dell(conf-if-te-1/10)#dampening 20 800 4500 120
Dell(conf-if-te-1/10)#
Related
Commands
Commands
specified interface.
description
Assign a descriptive text string to the interface.
S4820T
Syntax
description desc_text
To delete a description, use the no description command.
To delete a description, use the no description command.
Interfaces
793