Enterasys Networks 6H3xx ユーザーガイド

The following describes how to configure a port using the Rate Limiting Configuration screen:

1. To enter a Port Type, proceed to 

. To enter a port number, proceed as follows:

a. Use the arrow keys to highlight the field (1) below the Port Number field.

b. Type in the port number and press ENTER.

c. Proceed to 

2. To enter a Port Type, proceed as follows:

a. Use the arrow keys to highlight the Port field (near the bottom of the screen) and press the 

SPACE bar. Port Number changes to Port Type and the field below it changes to [all 
10Mbps enet].

b. Use the arrow keys to highlight the [all 10Mbps enet] field below the Port Type field.

c. If the port type [all 10Mbps enet] is not the selection needed, press the SPACE bar to select 

either [all 100Mbps enet] or [all 1Gbps enet].

Max Rate: kbps
(Modifiable)

Enter the maximum transmission rate for this entry. The maximum 
transmission rate includes all frames associated with the priorities 
selected in the Priority List field. The default high setting is 100 Kbps 
maximum interface speed. The high range setting is 100 Kbps to 
1 Gbps. The low range setting is 50 to 40000 Kbps.

For details on configuring a port, refer to 

.

NOTE: For further details on configuring the rate limiting 
range on a port, refer to the rate_limit_mode command in 

ADD 
(Command) 

Add the current port, priority, and maximum rate selections to the 
screen. For details about how to configure and add an entry, refer to 

DEL ALL/DEL 
MARKED 
(Toggle)

Delete all or one or more marked entries. The DEL ALL command is 
the default and it is used to simultaneously delete all the lines of 
configured information. The DEL MARKED command appears in 
place of the DEL ALL command when one or more lines are marked 
for deletion. For details on using the two commands, refer to