Extron electronic MVX 88 Series ユーザーズマニュアル

N

For tabletop use, affix one of the supplied self-adhesive rubber feet to each corner of 

the bottom of the switcher.

All of the MVX Series VGA switcher models are housed in rack-mountable, 1U 

high, full rack wide metal enclosures.  The appropriate rack mounting kit is 

included with each switcher.  Rack mount the switcher as follows:

The following Underwriters Laboratories (UL) guidelines pertain to the installation 

of the MVX into a rack.

. 

 — If the equipment installed in a 

closed or multi-unit rack assembly, the operating ambient temperature of the 

rack environment may be greater than room ambient temperature.  Therefore, 

install the MVX in an environment compatible with the maximum ambient 

temperature (Tma = +122 °F, +50 °C) specified by Extron.

. 

 — Install the equipment in a rack so that the amount of air 

flow required for safe operation of the equipment is not compromised.

. 

 — Mount the equipment in the rack so that a hazardous 

condition is not achieved due to uneven mechanical loading.

. 

 — Connect the equipment to the supply circuit and 

consider the effect that circuit overloading might have on overcurrent 

protection and supply wiring.  Appropriate consideration of equipment 

nameplate ratings should be used when addressing this concern.

. 

 — Maintain reliable grounding of rack-

mounted equipment.  Pay particular attention to supply connections other 

than direct connections to the branch circuit (e.g. use of power strips).

. 

If feet were previously installed on the bottom of the switcher, remove them.

. 

Attach the rack mount brackets to the switcher with the eight #8 machine 

screws provided (figure 2-1).

. 

Insert the switcher into the rack, aligning the holes in the mounting bracket 

with those of the rack.

. 

Secure the switcher to the rack using the supplied machine screws.