HP (Hewlett-Packard) RPC-2 RDR ユーザーズマニュアル
RPC SERIES OWNER’S MANUAL
RPC SERIES QUICK START (RPC-2 MD01 AND RPC-2 RDR)
________________________________________________________________________________
RPC SERIES QUICK START (RPC-2 MD01 AND RPC-2 RDR)
________________________________________________________________________________
5
RPC-2 MD01 AND RPC-2 RDR QUICK START
Local access
Using the 9FRJ45PC-1 adapter and the
using EIA-232 serial
RJ08X007 (8-pin crossed) cable, connect the
connection
serial port of your computer to the RJ-45
port labeled “EIA-232.”
port labeled “EIA-232.”
Load serial port communications software.
Set serial communications parameters to
9600 bps, 8 data bits, 1 stop bit, and no
parity.
Set serial communications parameters to
9600 bps, 8 data bits, 1 stop bit, and no
parity.
Remote access
using modem
connections
using modem
connections
RPC-2 MD01
Using the RJ04X007 (RJ-11) modular cable,
(Internal Modem)
connect either port labeled “LINE” on the
RPC unit to the telco wall jack. Proceed to
“Accessing Main Menu via Modem.”
RPC unit to the telco wall jack. Proceed to
“Accessing Main Menu via Modem.”
RPC-2 RDR
Plug the modem’s power supply into
(External Modem)
receptacle number six on the RPC. See
figure 1 below.
figure 1 below.
Figure 1: RPC-2 RDR to modem connection