HP (Hewlett-Packard) 331404-008 ユーザーズマニュアル

ページ / 176
 
Information Menu  34  
 
 
(UNK), the MAC address has not yet been learned by the GbE2 Interconnect Switch, but has only been seen as a 
destination address. When an address is in the unknown state, no outbound port is indicated. 
Clearing entries from the forwarding database 
To delete a MAC address from the forwarding database (FDB), see the “Static FDB configuration” section in the 
“Configuration Menu” chapter. To clear the entire forwarding database (FDB), see the “Forwarding Database 
options” section in the “Maintenance Menu” chapter.  
Link Aggregation Control Protocol information 
Command:   
/info/l2/lacp
 
[LACP Menu] 
     aggr     - Show LACP aggregator information for the port 
     port     - Show LACP port information 
     dump     - Show all LACP ports information 
 
The following table describes the Link Aggregation Control Protocol Menu options.  
Table 20 
 LACP information
 
Command Usage 
aggr 
Displays LACP aggregator information for the port.  
port 
Displays LACP information for the port.  
dump 
Displays all LACP information parameters.  
 
LACP dump  
Command:   
/info/l2/lacp/dump
 
>> LACP# dump 
port  lacp      adminkey  operkey  selected    prio    attached  trunk 
                                                         aggr 
---------------------------------------------------------------------- 
   1  off             1        1         n    32768        --     -- 
   2  off             2        2         n    32768        --     -- 
   3  off             3        3         n    32768        --     -- 
   4  off             4        4         n    32768        --     -- 
   5  off             5        5         n    32768        --     -- 
   6  off             6        6         n    32768        --     -- 
   7  off             7        7         n    32768        --     -- 
   8  off             8        8         n    32768        --     -- 
… 
 
LACP dump includes the following information for each port in the GbE2 Interconnect Switch:  
 
lacp—Displays the port’s LACP mode (active, passive, or off). 
 
adminkey—Displays the value of the port’s adminkey. 
 
operkey—Shows the value of the port’s operational key. 
 
selected—Indicates whether the port has been selected to be part of a Link Aggregation Group.  
 
prio—Shows the value of the port priority. 
 
attached aggr—Displays the aggregator associated with each port.  
 
trunk—This value represents the LACP trunk group number.