ZyXEL Communications XGS-4526 ユーザーズマニュアル

Chapter 46 Access Control

XGS-4526/4528F/4728F User’s Guide

Get Community Enter the Get Community string, which is the password for the 

incoming Get- and GetNext- requests from the management station.

The Get Community string is only used by SNMP managers using 
SNMP version 2c or lower.

Set Community

Enter the Set Community, which is the password for incoming Set- 
requests from the management station. 

The Set Community string is only used by SNMP managers using 
SNMP version 2c or lower.

Trap 
Community

Enter the Trap Community string, which is the password sent with 
each trap to the SNMP manager.

The Trap Community string is only used by SNMP managers using 
SNMP version 2c or lower.

Trap 
Destination

Use this section to configure where to send SNMP traps from the Switch.

Version

Specify the version of the SNMP trap messages. 

IP

Enter the IP addresses of up to four managers to send your SNMP traps 
to.

Port

Enter the port number upon which the manager listens for SNMP traps.

Username

Enter the username to be sent to the SNMP manager along with the 
SNMP v3 trap.

Note: This username must match an existing account on the Switch 

(configured in the Management > Access Control > SNMP 
> User screen). 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The 
Switch loses these changes if it is turned off or loses power, so use the 
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Table 151   Management > Access Control > SNMP  (continued)