ZyXEL Communications XGS-4526 ユーザーズマニュアル

 Chapter 46 Access Control

XGS-4526/4528F/4728F User’s Guide

From the SNMP screen, click Trap Group to view the screen as shown. Use the 
Trap Group screen to specify the types of SNMP traps that should be sent to each 
SNMP manager.

Figure 219   Management > Access Control > SNMP > Trap Group 

The following table describes the labels in this screen. 

Table 152   Management > Access Control > SNMP > Trap Group 

Trap 
Destination IP

Select one of your configured trap destination IP addresses. These are 
the IP addresses of the SNMP managers. You must first configure a trap 
destination IP address in the SNMP Setting screen. 

Use the rest of the screen to select which traps the Switch sends to that 
SNMP manager. 

Type

Select the categories of SNMP traps that the Switch is to send to the 
SNMP manager. 

Options

Select the individual SNMP traps that the Switch is to send to the SNMP 
station. See 

 for individual trap descriptions.

The traps are grouped by category. Selecting a category automatically 
selects all of the category’s traps. Clear the check boxes for individual 
traps that you do not want the Switch to send to the SNMP station. 
Clearing a category’s check box automatically clears all of the category’s 
trap check boxes (the Switch only sends traps from selected categories).

Apply

Click Apply to save your changes to the Switch’s run-time memory. The 
Switch loses these changes if it is turned off or loses power, so use the 
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.