Lucent Technologies P332MF ユーザーズマニュアル
Chapter 6
Cajun Campus CLI – Layer 2
Cajun P332MF User’s Guide
39
Clear screen Command
The clear screen command clears the current terminal display.
The syntax for this command is:
clear screen
Ping Command
Use the
ping command to send ICMP echo request packets to another node on
the network.
The syntax for this command is:
ping [host[number]]
ping [host[number]]
Note: You can use this command via the Master module only.
Example:
To ping the IP number 149.49.48.1 ten times:
Cajun_P330-N> ping 149.49.48.1 10
Cajun_P330-N> ping 149.49.48.1 10
ping 149.49.48.1 10: 56 databytes
64 bytes from 149.49.48.1: icmp_seq=0. time=8 ms
64 bytes from 149.49.48.1: icmp_seq=0. time=8 ms
Show Commands Summary Table
Following is a table of the
show commands:
host
Host IP address/Internet address of route destination. If missing then
the last host IP is used.
the last host IP is used.
number
Number of packets to send. If missing then the last number is used
• show time
Show current time
Page 41
• show timezone
Show the current timezone offset
Page 41
• show ntp
Display the current Network Time
Protocol (NTP) status and parameters
Protocol (NTP) status and parameters
Page 41
• show ip route
Show IP routing table entries
Page 42
• show image
version
Show the image version
Page 42
• show snmp
Show SNMP community strings
Page 43
• show snmp retries
Show SNMP retries number
Page 43
• show snmp timeout
Show SNMP timeout
Page 43