Intel 5800/120Ld ユーザーズマニュアル
B-12 Management Workstation Application
Using MWA
Opening a Server Window
To remotely access a managed server from the management PC using MWA,
you must open a server management window for the server. You can then issue
commands to the server and make various settings though this window.
you must open a server management window for the server. You can then issue
commands to the server and make various settings though this window.
There are two ways to open a server window:
!
Using a command — Select Open from the File menu. The Select a
Server dialog box displays. Select the server you want to remotely
access.
Server dialog box displays. Select the server you want to remotely
access.
!
Automatic connection — If a server is set for automatic connection,
MWA opens a server window and connects to the server when a
notification is received from the server. Refer to Connection and
Disconnection in the next section.
MWA opens a server window and connects to the server when a
notification is received from the server. Refer to Connection and
Disconnection in the next section.
Connecting and Disconnecting the Server
MWA is a pre-boot management application. MWA can be connected to a
server only from the time the server is powered on or reset until the operating
system is booted in the server. Once a server is connected, the remote control
function displays the server screen in the server window at the management PC.
Most MWA functions can be executed only when a server is connected.
server only from the time the server is powered on or reset until the operating
system is booted in the server. Once a server is connected, the remote control
function displays the server screen in the server window at the management PC.
Most MWA functions can be executed only when a server is connected.
Connect to a server as follows:
!
Connect command — Select Connect from the Pop-up menu in the
server window.
server window.
!
Setting automatic connection — Select Properties from the Pop-up
menu in the server window. The Server Properties dialog box displays.
Check [Activate] for RESET or POST Error alert on the Alert page.
After this setting is made, MWA will automatically connect to the server
each time a specified alert is reported from the server.
menu in the server window. The Server Properties dialog box displays.
Check [Activate] for RESET or POST Error alert on the Alert page.
After this setting is made, MWA will automatically connect to the server
each time a specified alert is reported from the server.
Disconnect a server from the management PC using one of the following
commands:
commands:
!
Disconnect command — Select Disconnect from the Pop-up menu in
the server window.
the server window.
!
Close command — Close from the File menu closes the active server
window and closes the connection to the server.
window and closes the connection to the server.
!
Exit command — Exit from the File menu terminates MWA and closes
the connections to all servers.
the connections to all servers.
!
Server reset or reboot — When a server is reset, its connection to
MWA is closed. If automatic connection is set for the server, the server
is connected again.
MWA is closed. If automatic connection is set for the server, the server
is connected again.