Intel 5800/120Ld ユーザーズマニュアル

When a remote drive is in use, [RD] displays in the title bar of the server
window. To connect to a remote drive, perform the following steps:

1.  Select Properties from the Pop-up menu in the server window to open the

Server Properties dialog box. Select the Remote Drive page.

2.  At the Remote Drive page, select the remote drive to use. Select [Floppy A:]

or [FD Image File]. If [FD Image File] is selected, enter the file name of the
FD image. The FD image file should be created in advance.

 If [Read Only] is checked, a FD image file can be

used in some servers.

To change the remote drive FD image file:

1.  Select the Change Remote Drive command from the Pop-up menu in the

server window. The Temporary Change to Remote Drive dialog box opens.

2.  Select [Floppy A:] or [FD Image File]. If [FD Image File] is selected, enter a

file name.

 If [Read Only] is checked, a FD image file can be

used in some servers.

 The Server must be reset after a remote drive is

used in the server.

MWA can pause server processing during or at the end of the server Power On
Self Test (POST.)

Set a server pause as follows:

!

 

Pause command — During server POST, select Pause POST from the
Pop-up menu in the server window. The server pauses immediately.
When the Go to End of POST command is executed, the server pauses
again after completing the POST.

!

 

Pause at Next Connect command — To set pause at the next server
connection, select the Pause at Next Connect command from the Pop-up
menu in the server window. When pause is set, a check mark appears
next to the menu item.

!

 

Pause at POST error command — Select Properties from the Pop-up
menu in the server window to open the Server Properties dialog box.
Check [Activate] for POST error alert on the Alert page. When MWA
receives this alert message from the server, MWA will connect to the
server and the server POST will be paused