HP (Hewlett-Packard) RP3440 ユーザーズマニュアル
Figure 5-1 Control Panel LEDs
Power and System LEDs
The power and system LEDs indicate the state of the system. When the system LED is flashing
yellow or red, a problem exists.
yellow or red, a problem exists.
lists the system LED states.
Table 5-3 System LED States
State
System LED
AC power is off if the power LED is off
Off
Running OS
Solid green
Booting or running BCH
Flashing green
Attention: Alerts of levels 3-5 detected in the iLO MP logs
The LED turns off once the event log has been read
The LED turns off once the event log has been read
Flashing yellow (1/sec.)
Fault: System Alert 7 detected, LED blinks until the problem is resolved and the
system boots successfully
Fatal hardware error detected by BMC, LED blinks until the problem is corrected
system boots successfully
Fatal hardware error detected by BMC, LED blinks until the problem is corrected
Flashing red (2/sec.)
For system alerts of levels 3-5, clear the attention condition on the LED. To access the logs, use
the SL command available in the iLO MP command mode.
the SL command available in the iLO MP command mode.
The fault condition for system alerts of level 7 is cleared by resolving the problem and cycling
power. For additional error information, see the SL error logs.
power. For additional error information, see the SL error logs.
NOTE:
Before replacing any hardware, check the iLO MP status logs in the case of a flashing
yellow or red system LED.
LAN LEDs
The front panel LAN LED indicates the system is communicating over the Gigabit:
Flashing green
The system is communicating over the LAN; the LAN is active.
Not green
No LAN cable is attached; LAN network is dead or the system is off or
the LAN link is not established; no current LAN activity.
the LAN link is not established; no current LAN activity.
lists the 10/100/1000 base-T Ethernet LAN connectors LEDs.
118
Troubleshooting