Lucent Technologies lucent ユーザーズマニュアル

Issue 1

August 1997

Error Messages 

Page A-111

test card-mem 

If all of the available maintenance resources are currently in use, then the following 
message will be displayed:

All maintenance resources busy; try again later

If the system technician presses 

HELP

 after entering "test card-mem", the following 

message is displayed for a simplex switch configuration:

Enter [’long’ or ’short’], [’repeat’ (1-100)

or ’clear’], [’schedule’]

For a duplex switch configuration, the following message will be displayed:

Enter [cabinet(1)];carrier(A-B), [’long’ or ’short’],

[’repeat’ (1-100) or ’clear’], [’schedule’]

If the SPE is not active, the following message will be displayed:

Command must be executed from active SPE

If the carrier entered is invalid, the following message will be displayed:

"entered value" is an invalid identifier;

press RETURN to execute modified command

If the NETCON board is not TN777B, the following message is displayed:

Must install TN777B circuit pack

If the command entered is in conflict with another currently executing command, then a 
message will be displayed showing the login id of the conflicting user and the conflicting 
command. The message is as follows:

’login id’:’command’ has a command conflict

If the standby is entering maintenance mode when this command is executed, then the 
following message is displayed:

Cannot interrupt Standby SPE while entering

maintenance mode; please try later

If the standby SPE is not refreshed when this command is executed, then the following 
message is displayed:

Standby SPE memory not refreshed;

use the "refresh spe-standby" command.