Patton electronic 2960 ユーザーズマニュアル

Introduction

Model 2960/2996 RAS User Manual 

This chapter contains the following procedures for installing the Model 2960/2996 RAS:

•

“Unpacking the Model 2960/2996 RAS”—lists the contents of the RAS shipping container

•

“RAS chassis installation”—describes installing the RAS on a flat surface or in a standard 19–inch rack.

•

 on page 21—describes installing the power and network interface cables

•

 on page 25—describes testing the RAS hardware to verify that it is 

ready for software configuration.

Inspect the shipping carton for external damage. Note any damage before removing the container contents. 
Report equipment damage to the shipping carrier immediately for claim purposes. Save all packing materials in 
case you need to return an item to the factory for servicing.

The RAS comes with the following items:

•

The 2960/2996 Series Remote Access Server (RAS)

•

A DB-9-to-RJ-45 (EIA-561) cable, 10 foot (3 meters)

•

Control port interface cable, 10 foot (3 meters), standard CAT-5 cable

•

Two WAN connection cables, 10 foot (3 meters) each

•

Rack mounting kit with rack ears and mounting hardware

Power cables are shipped separately from the Model 2960/2996 RAS.

Do the following:

1. If you have not done so already, remove the RAS from its shipping container.

The RAS should be placed as close as possible to the termination jack 
provided by the Telco. Avoid installing the RAS in a location where 
the power cords or network interface cables could be accidentally dis-
connected. The location should be well ventilated. Do not block the 
RAS’s cooling vents.

2. If you are installing the RAS in a 19-inch rack, go to step 3. Otherwise, place the RAS at the desired loca-

tion, then go to 

 on page 21.

3. Install the rack mounting ears onto the RAS using the mounting hardware provided.

4. Place the RAS at the desired position in the rack.

5. Secure the RAS in position with the mounting screws.