Patton electronic 29XX ユーザーズマニュアル

ページ / 326
Configuring Frame Relay
321
Access Server Administrators’ Reference Guide 
C • Technical Reference
Configuring IP routing with a Frame Relay Link
As each properly configured DLCI will have an IP address representing the next hop on that link, the access 
server can use a Frame Relay link to access many remote networks. The IP address of the Frame Relay link is 
unnumbered and specifies the next hop to another router. As such, it is a single-host route with a mask of 
255.255.255.255. By using the access server’s routing table, you can apply any number of network routes to 
use the Frame Relay link. You can even use a PVC as the default gateway (0.0.0.0).
Do the following to access the IP routing table in the access server:
1. Click on 
IP
 under the 
Configuration Menu
 to display the 
IP 
window (see 
2. Click on 
Routing Info
.
When the Frame Relay link (DLMI) and a DLCI is in the UP state, its IP address and interface, will appear in 
the IP Routing table. The IP address of the PVC will not appear in the IP routing table if the Frame Relay link 
is down, or the DLCI is not configured or inactive.
Figure 131. IP routing with Frame Relay example
, the Frame Relay link shows the address of 192.168.1.3. As IP routing dictates the best fit for any 
forwarding decisions, any destination with this address will automatically be sent across the Frame Relay link.
A network route using the Frame Relay link as its next hop is also shown in 
. The destination of 
192.168.1.0 255.255.255.255 specifies the gateway, or next-hop, of 192.168.1.3. With this entry, any IP 
packet with the destination address in the range of 192.168.1.1- 192.168.1.254 will automatically be sent 
down the Frame Relay link to the device with the IP address of 192.168.1.3.
Adding a route. To add a route, do the following:
1. To access the IP routing table in the access server, click on 
IP
 under the 
Configuration Menu
 to display the 
IP
 window (see 
 2.  Click on 
Routing Info
.
Note
To add a network route, use the second set of entry items which allow for a 
destination, mask and gateway: