Canon GM-1000 ユーザーズマニュアル

 

CANON  Digital Galvano Scanner System  GM-1000 Series 
Users Manual 1.20 
 
 

38

Since the controller and motor generate heat, their heat radiation should be considered carefully. 

Generated heat depends on the operating conditions. Determine a heat radiation method according to 

the operating conditions. 

The controller and motor have a temperature detection sensor (thermistor) in the heat generating 

section. As a safety function, the thermistor stops control if the detector temperature reaches: 

Controller About 

70ºC 

Motor About 

70ºC 

(For details, see 10.1.   “Safety Functions”) 

The controller and motor require heat radiation so that their temperatures will not exceed the above values. 

The controller can be installed by either method A or B below. 

At installation, put the controller frame in contact with a heat-radiating structure (heat sink or cabinet). 

Method A has higher heat radiation efficiency. However, select either method by considering the 

operating conditions and cable routing. When installing the controller frame, apply thermal grease or 

attach a thermal conductive sheet to the contact surface. 

Under some operating conditions, forced air cooling by a fan is necessary. Cool the heat-radiating 

structure (heat sink or cabinet) and the controller.

 
 
 
 
 
 
 
 
 
 
 
 

In addition to the output amplifier, the control circuit section (DSP) generates heat. 

Allow as much space as possible around the equipment. 

The controller becomes hot during operation. 

Output amplifier 

Control circuit