Canon DR-2010C ユーザーズマニュアル

Previous Page Next Page

Click the [Others] tab 

→ select the document feeding method in [Feeding 

Option].

•

Details of each feeding method are indicated below.

This feeding method is good for scanning small batches of documents that are 
loaded one batch at a time: scanning stops when the loaded documents have 
been scanned. 

This feeding method is good for scanning batches of documents of different 
sizes: after loading the documents, press the Job button (assigned as a Start 
button on the scanner) to start scanning, and press the assigned Stop button to 
stop scanning. 

y When scanning documents with different-size pages, after loading the 

documents, you can adjust the document guide position. 

This feeding method is good for scanning batches of same-size documents: 
scanning starts when the scanner detects loaded documents, and stops when 
you press the Stop button. 

y When [Automatic Feeding] is selected, the [Setting] button is enabled to 

allow setting the delay time from when a loaded document is detected until 
scanning starts. The delay time can be set from 0 to 60 seconds.

When the separation timing to use when scanning starts with batch separation 
enabled in the application. (If [Standard Feeding] is selected, batch separation 
is disabled.)
If you selected [Panel Feeding] or [Automatic Feeding] for the feeding method:

Document batches are separated automatically.

Document batches are separated when the [Batch Separation] button on the 
Scan Panel is pressed. (See "Using the Scan Panel," on p. 28.)