Sharp AR-M257 ユーザーズマニュアル

If you find that a notice page has been printed at the end of a print job, the print data received from the computer has not been 
printed as specified. Fix the problem as explained below and then try printing again.

If the following Notice Page is printed, check your settings for the Staple function.

☞

Disable the ROPM function by removing the checkmark from 
"ROPM" in the "Configuration" tab of the printer driver setup 
screen. (See "CONFIGURING THE PRINTER DRIVER" in the 
software setup guide.) If you wish to use the ROPM function, 
set the print quality to "Draft" or increase memory.

Select "Draft" for the "Print quality" setting, or increase the 
value set for "MEMORY FOR PRINTER" in the key operator 
programs. If this does not solve the problem, add more IMC 
memory.

Notice page printing can be disabled using a key operator program (see "PROHIBIT NOTICE PAGE PRINTING" in the key operator's 
guide).

****************************************************

Notice Page

****************************************************

The IMC memory full error had occurred,

a normal output was not able to be executed.

Please refer to the operation manual for

the solution method.

The IMC memory is used to store print data when the ROPM function is used. This memory is also used to store original image data 
in the copy mode. The percentage of IMC memory allocated to the printer function can be adjusted using a key operator program. 
See "MEMORY FOR PRINTER" in the key operator's guide. The memory can be extended by adding commercially available 
memory modules. For details, contact your SHARP dealer.