IBM 5.5 ユーザーズマニュアル
60
neName,NEType,host,port,usr,pwd,connType,protType,scenario,run_fir
st_enabled,run_always_enabled,cron_tab
See Table 7 for details of each parameter.
An example of one line in the hosts file is as follows:
NE1,OVM_ADM_V2,10.0.0.176,3082,user1,pwd1,telnet,TL1,scenario_name,,,2 * *
* *
Rules
The following rules apply to configuring connections to known devices:
•
All fields are mandatory and must be entered in the order specified in "Syntax" on
page 59.
page 59.
•
The last three fields can be omitted if the associated comma separator is retained to
indicate the position of the omitted parameter.
indicate the position of the omitted parameter.
Note:
All comma seperators are mandatory.
•
Lines starting with // indicate comments and are ignored.
Table 7. Hosts file parameters
Parameter
Value
neName
Name of the NE (the TID in TL1).
NEType
The NEType name of the NE.
host
Either the host name or the host IP address.
port
The port from which the NE accepts the management
session.
session.
usr
Authentication user name.
pwd
Authentication password.
connType
Name of the type of connection (for example, telnet, tcp, and
so on.)
so on.)
protType
Name of the type of protocol (for example, TL1, SNMP, and
so on.)
so on.)
scenario
Scenario name, mainly used for TL1 devices.
run_first_enabled
Boolean value of either true or false used to determine
whether asset polling is to be run the first time the schedule
is enabled. The default value is false.
whether asset polling is to be run the first time the schedule
is enabled. The default value is false.
run_always_enabled
Boolean value of either true or false used to determine
whether asset polling is to be run every time the schedule is
enabled. The default value is false.
whether asset polling is to be run every time the schedule is
enabled. The default value is false.
cron_tab
The cron tab defining the asset polling run times.