Chicago Electric 42933 ユーザーズマニュアル

SKU 42933 

Page 10

Power 

Requirements

120 V~, 60 Hz, 1-ph

20.9 A (start); 6.9 A (load); 1330 W

Motor

1-3/4 HP, 4200 spindle RPM, 

electric brake

Saw Blade

8-1/4” (dia.)

Arbor

5/8”

Crosscut Distance 11” (maximum)

Rip Cut Distance 20” (maximum)

Depth of Cuts

45°: 2”;  90°: 2-1/8”

Bevel Index Stops 0, 45, 90°

Mitre Index Stops Left and right: 0, 15, 30, 45, and 60°

Table Size

15-1/16 x 27-5/8 x 3/4”

Accessories

Blade Replacement: Item # 43204

note: Performance of this tool may vary 

depending on variations in local line 

voltage. Extension cord usage may 

also affect tool performance.

When unpacking, check to make sure 

that all the parts are included. Refer to the 

Parts List and Assembly Drawing at the 

end of this manual. If any parts are miss-

ing or broken, please call Harbor Freight 

Tools at 1-800-444-3353 as soon as pos-

sible.

During the assembly and installation 

procedure, you may have to refer to the 

Parts List and Assembly Drawings located 

at the end of this manual.

Secure the Radial Arm Saw to a solid 

1. 

bench top (or table) by bolting (or 

clamping) the saw frame down to the 

bench top.

The workbench must not be able to 

• 

slide or tip over. Affix to floor if nec-

essary.
Position the Radial Arm Saw (or saw 

• 

and bench) to slope slightly to the 

rear so the radial arm carriage will 

not roll forward due to gravity.

The workbench should be of the ap-

• 

propriate length and width to allow 

the operator to stand aside of the 

saw blade, whatever position the 

saw blade is in.
The work area should have ade-

• 

quate, overhead, non-glare lighting.
Lock the radial arm carriage before 

• 

moving the unit.

2.  Turn the Base (152) assembly upside 

down. Attach Table A (127) squarely 

to the Base assembly using the four 

cross-head Tapping Screws (165).
Attach the table stabilizer Stands  to 

3. 

both sides of the Base using four Hex 

Nuts (82), Washers (149), and Round 

Head Bolts (148).
Place the Table and Base assem-

4. 

bly on the workbench, right side up. 

Secure to the workbench with nuts, 

bolts, and washers (not supplied).

5.  Position Table B (126) and Table C 

(125), and the rip fence (guide) and