Wagner SprayTech 558047 ユーザーズマニュアル

 12 

ProSpray 3.23

Cleaning the unit (shutting down) 

  1.  Screw off the filter (Fig. 7) from suction pipe.
  2.  Clean or replace the filter.
Carry out cleaning with a hard brush and an appropriate cleaning 

agent.

Clean the filter cartridge regularly.
A soiled or clogged high-pressure filter can cause a poor spray 

pattern or a clogged tip.
  1.  Turn the pressure control knob counterclockwise to minimum 

pressure.

  2.  Open the relief valve, valve position PRIME 

   (k circulation).
  3.  Switch the unit OFF.

 4.  Unscrew the filter housing (Fig. 8, Item 1). with a strap wrench.
  5.  Pull the filter cartridge (2) from the bearing spring (3).
  6.  Clean all the parts with the corresponding cleaning agent. If 

necessary, replace the filter cartridge. 

  7.  Check the O-ring (4), replace it if necessary.
  8.  Place the bearing ring (5) against the bearing spring (3). Slide 

the filter cartridge (2) over the bearing spring. 

  9.  Screw in filter housing (1) and tighten it as far as possible with 

the strap wrench.

  1.  Rinse Airless spray gun with an appropriate cleaning agent.
  2.  Clean tip thoroughly with appropriate cleaning agent so that 

no coating material residue remains.

  3.  Thoroughly clean the outside of the Airless spray gun.

Intake filter in Airless spray gun
Disassembly (Fig. 9)
  1.  Pull protective guard (1) forward vigorously.
  2.  Screw grip (2) out of the gun housing. Remove intake filter (3).
  3.  Intake filter congested or defective – replace.

Assembly
  1.  Place intake filter (3) with the long cone into the gun housing.
  2.  Screw in grip (2) into the gun housing and tight en.
  3.  Slot in protective guard (1).

  W

arning:

keep clear

     of ti

p

         250 bar

max.3600 ps

i