Graco 16H245 ユーザーズマニュアル

Shutdown and Cleaning 

16

3A1698F

1.

Engage trigger lock and pull prime/pressure relief 
valve UP to release pressure.

2.

Remove material cup and return excess material to 
proper container. If used, properly dispose the cup 
liner. 

3.

Remove and clean sprayer intake tube and screen 
with water (or flushing fluid) and a brush every time 
you flush the sprayer. Reconnect intake tube.

4.

Clean cup if not using a liner, and fill with water or 
appropriate flushing fluid.

5.

Reconnect material cup and shake sprayer to move 
clean water around and clean all areas inside of 
cup.

6.

Disconnect trigger lock and trigger sprayer for 
approximately 15 seconds. Engage trigger lock.

7.

Discard contaminated fluid and refill with appropri-
ate flushing fluid.

Failure to properly clean sprayer after each use will 
result in hardened materials, damage to the sprayer, and 
the warranty will no longer be valid. Do not store solvents 
other than mineral spirits in sprayer. Always flush with 
Graco pump armor prior to storage.

Do not spray solvents through the spray tip. Clean the tip 
in a bucket of compatible solvent.

Keep spray area well-ventilated. Keep a good supply of 
fresh air moving through the area.

Protect the internal parts of this sprayer from water. 
Do not submerge the sprayer in cleaning fluid. Openings 
in shroud allow cooling of mechanical parts and electron-
ics inside. If water or cleaning fluid gets into these open-
ings, the sprayer could malfunction or become 
permanently damaged.

i14994

ti16699a

ti16700a

ti15000a

ti16724a

ti15002a

ti16725a

ti15001a

ti16726a

ti15441a

ti16723a

ti16993a

ti16716a