Hitachi NR 83AA4 ユーザーズマニュアル

13

(3)  Pull the nail feeder (B) back to engage the nail feeder 

(A) to the nail strip.

Nail Feeder (B) 

Nail Feeder (A)

●  Quietly push the Nail Feeders (A) and (B) against the 

nail.

  If the Nail Feeders (A) and (B) are released from 

backward the magazine and bumped against the nail, 

the connecting paper of the nail can be damaged.

●  Use nail strip of more than 5 nails.

The Nailer is now ready to operate.
Removing the nails:

1  Pull the nail feeder (B) backward.

2 Return the nail feeder (B) forward quietly while 

pushing the nail feeder (A).

3  Push the nail stopper toward the magazine side, and 

pull out nails from the back of the magazine.

1

2

2

Nail Feeder (A)

Nail Feeder (B)

Adjust the air pressure at recommended operating 

pressure 70 – 120 psi (4.9 – 8.3 bar  5 – 8.5 kgf/cm

2

) 

according to the length of nails and the hardness of 

workpiece.

The correct air pressure is the lowest pressure which will 

do the job. Using the Nailer at a higher than required air 

pressure unnecessarily over stresses the Nailer.
LOADING NAILS

(1)  Insert nail strip into rear of magazine.

Magazine

(2)  Slide the nail strip forward in the magazine.

 

The nail strip should pass the nail stopper.

Nail Stopper

000Book_NR83AA4_US.indb   13

000Book_NR83AA4_US.indb   13

2013/04/23   15:04:13

2013/04/23   15:04:13