Echo GT-2000 ユーザーズマニュアル

5.

After engine fires or five (5) pulls, move choke lever to “Run”
position. Hold throttle trigger fully depressed and pull starter
handle/rope until engine starts and runs. Release throttle trigger
and allow unit to warm up at idle for several minutes.

NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions.

6.

After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.

The cutting attachment should not rotate at idle. If attachment
rotates, readjust carburetor according to "Carburetor Adjustment"
instructions in this manual or see your ECHO Dealer, otherwise
serious personal injury may result.

1.

Stop Switch - Start/Run.  Move stop switch button (A) away from
the STOP position.

2.

Start - Pull Rope.  Lay the trimmer on a flat clear area and  pull
the starter handle (D) until the engine fires.

NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.

1.

Release Throttle.  Allow engine to idle for a minute.

2.

Stop Switch - Stop.  Move stop switch button (A) backward to
STOP position.

If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using trimmer
again.

NOTE
Refer to the Grass Trimmer / Brush Cutter Safety Manual for proper
and safe trimming techniques.