Zenoah EXZ2401S ユーザーズマニュアル

■ INSTALLING DEBRIS GUARD
• Put the debris guard on the gear box, attach it with

the 2 screws and hardware provided. (SE1)

■ INSTALLING CUTTING HEAD (SE2)
1. While locking the gear shaft, by inserting the

supplied tool into the upper holder on the gear box,
loosen and remove the hexagon nut(left-handed)

2. Then screw in the cutting head to the gear shaft over

the holders. Hand-tighten it securely.

■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with head

just touching on the ground. (SE3)

■ ATTACHING THE TRIMMING MECHANISM (SE1)
1. Remove the screw screwed into the end of the

trimming mechanism.

2. Insert the end of the trimming mechanism into the

main pipe.

3. Line up the hole on the end of the trimming

mechanism into which the screw is to be inserted
with the hole on the main pipe, and screw the screw
firmly in.

4. Using a wrench, screw in the bolt provided to fix the

trimming mechanism into place. 

■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up or

down until unit balances and the strap fits your body.