Husqvarna 536 LIR ユーザーズマニュアル

English

 –

 21

All servicing and repair work on the machine requires 
special training. This is especially true of the machine

′

s 

safety equipment. If your machine fails any of the checks 
described below you must contact your service agent. 
When you buy any of our products we guarantee the 
availability of professional repairs and service. If the 
retailer who sells your machine is not a servicing dealer, 
ask him for the address of your nearest service agent. 
Only use original spare parts.

Regularly check that the battery charger and the battery 
are intact.

Clean the machine after use. If the battery connector on 
the machine is dirty, clean it by blowing them with 
compressed air or use a soft brush.

Make sure the battery and battery charger are clean and 
that the terminals on the battery and the battery charger 
are always clean and dry before the battery is placed in 
the battery charger.

 Keep the battery guide tracks clean. Clean plastic parts 
with a clean and dry cloth. 

Check the line by threading it into the hole on the cover, 
as shown in the illustration.

Only use the recommended trimmer heads and trimmer 
lines. These have been tested by the manufacturer to suit 
a particular motor size. This is especially important when 
a fully automatic trimmer head is used. Only use the 
recommended cutting attachment. See the chapter on 
Technical data.

Check that the trimmer head is undamaged and not 
cracked. Replace the trimmer head if necessary.

•

Press the snap-in clips on the trimmer head and 
remove the trimmer head and line.

•

Pull out the line chute assembly.

•

Remove the nut holding the trimmer head and the 
drive disc.

•

Replace the trimmer head.

•

Install the drive disc and the trimmer head.

•

Fit the nut and the line chute assembly.

•

Fit the trimmer head.

IMPORTANT! Never clean the battery or the battery 
charger with water. Strong cleaning agents can damage 
the plastic.

Li-ion

Li-ion