Husqvarna 326ES ユーザーズマニュアル

English

 –

 11

1151020-95   Rev. 2   2008-03-10

The locking nut secures the cutting attachment on the 
output shaft.

Protect your hand from injury when assembling, use the 
blade guard as protection when tightening with a socket 
spanner.

When fitting, tighten the nut in the opposite direction to the 
direction of rotation of the cutting attachment. To remove 
it, undo the nut in the same direction as the cutting 
attachment rotates. (CAUTION! The nut has a left-hand 
thread.)

Tighten the nut using the socket spanner. 35-50 Nm (3.5-
5 kpm).

The nylon lining inside the locking nut must not be so worn 
that you can turn it by hand. The lining should offer a 
resistance of at least 1.5 Nm. The nut should be replaced 
after it has been put on approx. 10 times.

The locking screw secures the cutting attachment on the 
output shaft.

Protect your hand from injury when assembling, use the 
blade guard as protection when tightening with a socket 
spanner.

When fitting, tighten the screw in the opposite direction to 
the direction of rotation of the cutting attachment. To 
remove it, undo the screw in the same direction as the 
cutting attachment rotates. (CAUTION! The screw has a 
left-hand thread.)

Tighten the screw using the socket spanner. 18-25 Nm 
(1,8-2,5 kpm).