Husqvarna 326ES ユーザーズマニュアル
ASSEMBLY
12 – English
1151020-95 Rev. 2 2008-03-10
Fitting the loop handle
•
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
must be mounted below the arrow on the shaft.
•
Fit the bolt, securing plate and wing nut as shown in
the diagram.
the diagram.
•
Tighten the wing nut.
Assembling the angle gear
(326Ex)
(326Ex)
•
Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.
tube. Turn the blade so that the drive shaft engages in
the angle gear.
•
Position the angle gear so that its slot is aligned with
the line on the supporting tube.
the line on the supporting tube.
•
Firmly tighten the screw.
Assembling the angle gear
(326ES)
(326ES)
•
Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.
tube. Turn the blade so that the drive shaft engages in
the angle gear.
•
Tighten the two screws.