Husqvarna LE475 / 966951101 ユーザーズマニュアル

5

ASSEMBLY

TOOLS REQUIRED: 7/16" Wrench, Pliers,

Screwdriver

NOTE: Reference to Left or Right side of machine

is from the operator's position of the handle,

facing forward.

The lawn edger, except the handle and throttle

control, is fully assembled, packed, and shipped

in one container.

ATTACHING THE HANDLE

1. Remove handle brace, nuts, and bolts. Align

the handle, lower support, and handle brace

holes. Use all six nuts and bolts. Leave bolts

loose until Steps 2 and 3 are completed (See

Fig. 1).

2. Install control rod into upper and lower pivot

holes and secure with cotter pins (See Fig.

1). Oil pivots lightly before installing rod.

3. Move clutch-depth lever into rear notch of

quadrant on handlebards. Move cutterhead

angling lever to top notch of quadrant.

4. Remove spark plug wire from spark plug.

Move throttle to OFF position. Check clutch

operation by pulling recoil starter rope. If

blade turns when depth lever is in top notch,

loosen handle bolts and pull toward operator.

Snug bolts and check clutch operation again.

— IMPORTANT NOTE —

Make sure blade does not turn when lever is in

top notch (disengaged).

5. Slip on the handle grips.

6. Tighten bolts.

FILL ENGINE WITH OIL

NOTE: There is no oil in engine crankcase.
1. Follow instructions in the engine manual for

correct grade of oil, oil filling, and oil changing.

2. Do not mix oil with gasoline.

INSTALLING THE THROTTLE WIRE

1. If the throttle cable is not attached to the

engine carburetor, follow the instructions in

the engine operating manual. Some throttle

cables cannot be attached before shipping.

Check oil level of engine every time edger-

trimmer is used. An improper oil level can cause

extensive internal damage to engine.

FUEL SPECIFICATION

1. Follow fueling instruction in the engine

manual.

Handle fuel with care — it is highly flammable.

Use only approved fuel container. Never add

fuel while engine is running. Fill fuel tank

outdoors, with extreme care. Never fill fuel

tank indoors. Replace gasoline cap securely

and wipe up all spilled fuel.

CAUTION

Always clean area around fuel cap before

removing it to prevent excessive amounts of dirt

from entering fuel system. Also insure that the

fuel storage container you are using is clean and

in good condition.

CORRECT ENGINE OPERATION

Before starting engine, become familiar with

all controls. Read this Operator's Manual

thoroughly. Always check engine oil level

before starting engine.

CAUTION

Care should be taken to avoid inhaling ex-

haust gasses, as they contain carbon mon-

oxide gas, which is colorless and oderless.

Carbon monoxide is a dangerous gas that

can cause unconsciousness and is poten-

tially lethal. Do not run engine in confined

areas such as closed garages.

WARNING

Fig. 1

Throttle Cable

Throttle

Cable Clip

Install 6 Bolts Through

Handle Lower Support

& Handle Brace Holes

Control Rod