Husqvarna LE475 / 966951101 ユーザーズマニュアル

OPERATING YOUR EDGER-TRIMMER

Always disengage edger-trimmer blade and

shut engine off when leaving the edger-trim-

mer unattended, even if for just a few min-

utes. Prevent accidents; don't give children

or unauthorized persons an opportunity to

operate this machine.

CAUTION

CORRECT ENGINE OPERATION

Always start edger-trimmer in motion

slowly. Sudden starts can be damaging

to the equipment and could cause loss of

operator control.

CAUTION

Rotating blade can throw dirt or debris.

Wear safety glasses when operating the

edger-trimmer.

CAUTION

Never adjust cutterhead angle when engine

is running.

WARNING

ADJUSTING CUTTERHEAD ANGLE

(See Fig. 2)

Before starting engine, adjust cutterhead angle.

The cutterhead angling lever, located on the left

hand side of the frame, enables the operator

to position the blade horizontally for trimming

or choose several vertical positions for edging.

CLUTCH AND DEPTH LEVER

SETTINGS (See Fig. 3)

Clutch and Depth lever is used to engage and

disengage the drive belt, which operates the

blade. It is also used to regulate the depth of

edging and height of trimming.

STARTING THE ENGINE

Be sure the clutch lever is in the rear DISENGAGED

position before starting engine.

Manually pull out choke on engine.

Grasp the recoil starting handle and pull quickly.

Return the handle slowly. If the engine fails to

start after three or four pulls, lower the throttle

to the detented full throttle (fast) position.

Once the engine starts, push the choke to the off

position. Use the SLOW position to idle the engine.

ENGAGING THE DRIVE BELT

Move clutch and depth lever forward to engage

drive belt and blade. Notches in base of lever

permit adjusting depth of cut for edging and height

for trimming.

TO STOP

Disengage edger-trimmer clutch and depth lever.

Move throttle control to stop position. Make

sure engine is stopped and blade is not

rotating before leaving the operating position.

Cutterhead Angle Adjustmet

Fig. 2

Fig. 3

Throttle/Choke

Controls

Clutch/Depth Controls

Depth

Settings