Tascam D01175220A DP-006 ユーザーズマニュアル

4.  If a source that uses the INPUT A connector is selected as the INPUT A 

input source in step 2 above, set the MIC/LINE-GUITAR switch on the left 

side panel appropriately. Set it to GUITAR when connecting an electric 

guitar or electric bass directly. Set it to MIC/LINE when inputting a mic or 

line signal.

effect boxes between it and this unit, set the MIC/LINE-GUITAR switch to 

When an input source is set as the INPUT A or INPUT B connector on the rear 

panel, regardless of the REC button setting, the input signal is always sent to 

the stereo bus, so you can always monitor the input signal.
When an input source is set to a front panel built-in mic, the input signal is 

sent to the stereo bus and can be monitored only when the REC indicator 

light for the track that is set to record the built-in mic is blinking (during 

record standby) or lit (while recording). You cannot monitor the built-in mic 

input when the REC indicator is not lit.

When an input source is set as the INPUT A or INPUT B connector, during 

connected to the  /LINE OUT connector.

The monitoring mode can be set for the INPUT A/B signals.
1.  When the recorder is stopped, press the INPUT SETTING button to open 

the INPUT SETTING screen. 

2.  Use the F3 [5] and F4 [b] buttons to select the MODE item value, and 

use the DATA wheel to select (highlight) the input signal monitor mode.

MONOx2: INPUT A/B signals are output as mono signals from left 

and right channels.

STEREO:

INPUT A/B signals are output as left and right channels. 

3.  After completing the setting, press the HOME button to return to the 

Home Screen.