Anton/Bauer 90 ユーザーズマニュアル

 

 

 9  

 

 

•  When the DIONIC battery is being charged remaining runtime is 

not displayed. 
 

•  Remaining run time is calculated using the present available battery 

capacity and a constantly updated accurate measurement of the 
present load on the battery. 
 

•  If no load is detected, or if the battery is removed from the charger 

before any discharge load is applied, the default assumed power for 
remaining run time calculations is 20 Watts. 

 
•  When the battery determines that a load is attached, remaining run 

time will be calculated based on that load and the time remaining 
will be updated. 
 

•  The battery will “learn” this new load and retain that load 

information in non-volatile memory. If the battery is removed from 
the camera it will retain this information for 30 minutes or until it is 
returned to the charger or sees a new load. After 30 minutes the 
battery will return to the default load of 20 watts. 

 

• 

 If the DIONIC 90 battery is 

subjected to a load that exceeds specifications, the protection 
electronics will operate to protect the lithium ion cells. All status 
icons on the LCD will flash at a once per second rate. This can 
occur, for example, if a cold halogen light =/>75 watts is turned on. 
When the over-load condition is removed, the display will return to 
normal.